Welcome to our store Learn more

New collections added! Learn more

Flash Sale Now ON!

20% COUPON OFF

BINIZE202

How to replace Toyota Camry 2006-2011 Radio ?

YuanYuan Liu |

How to replace Toyota Camry 2006-2011 Radio ?

 

Looking to replace the factory radio for a Toyota Camry radio that is a bit more modern? The good news is you can get it by yourself. All you need is a new car stereo replacement and a little technical know-how. In this article, you will find something useful. Note: This article applies to the Toyota Camry 2006,2007,2008,2009,2010,2011.

 

Toyota Camry 2006-2011

 

Radio is the main entertainment hardware in your car. If it malfunctions, you would get any entertainment in your ride. Have you ever thought about playing Bluetooth music or apps in your car anytime, anywhere, or even putting your phone on your car stereo. Many car stereos now support these features. So it’s not difficult to get a Toyota Camry radio replacement.

 

1.Materials You Will Need

 

  • Pry tool
  • Phillips screwdriver
  • Socket wrench
  • Aftermarket Toyota Camry radio

 

Materials You Will Need

2.Remove the trim panel

 

For Toyota Camry, you should need to remove most of the center console trim panel to install the Toyota Camry radio. So you need to grab your crowbar and wedge it between the gearshift handle and the chrome plating to part them away. Then unscrew the transmission handle and remove the two trim pieces. I think it’s not difficult for customers to do this.

 

3.Remove Vent and bottom tray

 

After removing the trim panel, you can see two mounting screws on the bottom tray. Use A Phillips screwdriver to loosen the screws and pull out the tray. You need to disconnect the two accessory sockets before removing them completely.

 

4.Take off the radio bracket bolts

 

Four 10 mm bolts hold the radio bracket assembly in place. Use your screwdriver to remove them. Once the 10mm bolt is out, pull out the factory radio (while it is still connected to the bracket assembly) and disconnect the wire plug.

 

5.Remove the factory radio

 

The Toyota Camry radio is quite big, with three bolts on the left and right sides. You can remove it with an 8mm sleeve or a Phillips screwdriver. The climate control panel is in the same place by the same bracket. The climate control panel from the radio unit is needed to remove, you also need to remove the Phillips mounting screw.

 

New Toyota Camry car stereo

 

6.Put the car stereo replacement to the car

 

To replace Toyota Camry radio, you need to install it on the bracket in your .

 

  • Connecting to the climate control panel.
  • Connect the radio wire harness to the radio plug. (or every car stereo replacement will come with a labeled wires harness, it’s easy to plug into)
  • Put the bracket back on the car.
  • Install vent and bottom tray.
  • Install all removed trim panels you remove.
  • car stereo replacement installs successfully